JB Ignition Kit (no pulley)
  • JB Ignition Kit (no pulley)
  • JB Ignition Kit (no pulley)
  • JB Ignition Kit (no pulley)
  • JB Ignition Kit (no pulley)
  • JB Ignition Kit (no pulley)
  • JB Ignition Kit (no pulley)
  • JB Ignition Kit (no pulley)
  • JB Ignition Kit (no pulley)
  • JB Ignition Kit (no pulley)
  • JB Ignition Kit (no pulley)

JB Ignition Kit (no pulley)

SKU : IGN_KIT_NO_PULLEY
AU$500
Share:

Based on the tried and trusted Speeduino firmware our custom ECU has been designed to provide modern performance for your classic car and offers a range of enhancements for both standard and performance engines. Supplied in standard for as 4 cylinder wasted spark, the system is also capable of running sequential and other engine configurations and cylinder counts including rotary engines and twin spark. Full feature list is below.

The system is fully user mappable via bluetooth from either your laptop or android device (using MsDroid). You can also use your iPhone1 or Android device as dashboard to display engine parameters such as RPM, Boost / Vac, Voltage, Engine Temperature, Inlet Air temperature, Advance, Dwell, etc.

 

This kit comes supplied with the following items

  • Plug and play wiring loom
  • ECU
  • Coil pack
  • Head temp sensor
  • Inlet temp sensor
  • Crank trigger sensor and mounting bracket
  • Crank trigger wheel
  • Custom spark plug leads
  • Distributor delete plug
  • Pre-loaded timing map

Features include

  • User programmable
  • Bluetooth connectivity - program via laptop or Android device (IOS optional via wifi)
  • Crank triggered
  • Distributor-less
  • Switchable logic level outputs (5V or 12V)
  • Supports wasted spark, wasted COP and full sequential
  • Supports dual spark
  • CLT / IAT temperature correction tables
  • Voltage / Dwell correction tables
  • Launch control
  • Flat shift
  • Boost control
  • Shift light
  • Fuel pump control (auto prime & auto shutoff)
  • Rev limit
  • Remote dashboard compatible - Monitor all system I/O and functions via MSDroid or Shadowdash (MAP, RPM, CLT, IAT, Advance, Dwell, Voltage, etc)
  • 2 Stage Nitrous control
  • Water/meth injection control. (PWM via MAP / RPM tables & on/off control)2

NOTE: If this kit is purchased and shipped at the same time as one of our blower kits, we will carry out the following work for free3:

 

  • Trigger wheel will be mounted to the blower crank pulley
  • IAT sensor mounting will be welded into the tee manifold

 

  1. IOS devices (mobisquirt) require optional WiFi module in place of bluetooth
  2. Due for release early 2019
  3. Machining work can also be carried out respectively at the customers cost.