NEW: Ignition Kit

11.02.19 08:14 PM By Joe Blow

After looking for a cost effective user programmable ignition system that supports boosted setups we decided that the only things to do was to make our own.

Aimed specifically at providing boost referenced ignition control and replacing the 100 year old distributor technology with a modern solid state coil pack, our ignition system helps to make the most out of our blown setups.

Designed and built in house and based on the tried and trusted Speeduino firmware our custom ECU has been designed to provide modern performance for your classic car and offers a range of enhancements for both standard and performance engines. Supplied as 4 cylinder wasted spark setup, the system is also capable of running sequential ignition control as well as other engine configurations and cylinder counts including rotary engines. 

The system is fully user mappable via bluetooth from either your laptop using Tuner Studio, or from your Android device (using MsDroid). You can also use your iPhone or Android device as a remote dashboard to display engine parameters such as RPM, Boost / Vac, Voltage, Engine Temperature, Inlet Air temperature, Advance, Dwell, etc. The ECU is also compatible with PiDash.

Supporting Turbo boost control and direct Water / Meth injection our ECU is perfect for boosted setups

The ECU is supplied pre-programmed with our very own in-house developed ignition map along with a plug-and-play wiring loom.

Our ignition kit comes supplied with the following items

  • Plug and play wiring loom
  • ECU
  • Coil pack
  • Head temp sensor
  • Inlet temp sensor
  • Crank trigger sensor and mounting bracket
  • Crank trigger wheel
  • Custom spark plug leads
  • Pre-loaded timing map
  • Compatible with Tuner Studio

Joe Blow

Added to cart
- There was an error adding to cart. Please try again.
Quantity updated
- An error occurred. Please try again later.
Deleted from cart
- Can't delete this product from the cart at the moment. Please try again later.